In this paper, a bidirectional DC-DC converter with high power density for energy storage application is proposed. The presented converter provides power transfer in both directions only with adjusting phase shift angle. zero voltage switching (ZVS) in both turn on and turn off moments of all switches is the major capability of the converter that makes it suitable for high power applications. ZVS of the converter is provided without any auxiliary devices. High frequency transformers are employed in the converter construction to match the converter two sides voltage. Moreover, transformer leakage inductance along with external auxiliary inductance acts as energy storage in power transfer from one side of the converter to the other side. Operation principle of the converter in steady state is analyzed and then, its dynamic model is derived. ZVS criteria of the proposed converter are studied and finally, experimental measurement results of laboratory scale prototype are presented.

This paper proposes a new variable frequency zero voltage switching (ZVS) control method for boost converter operating in boundary conduction mode (BCM). The intended method keeps the converter in BCM despide of the  load and input voltage variations. This is done by changing switching frequency in a certain specified range. The proposed method can guarantee circuit performance in BCM via zero-crossing detection of the inductor current and changing the switching frequency. In addition, with a slight modification in control structure, it is possible to achieve a fully ZVS in all cases. This converter control is carried out in analog form without using microprocessors which, compared with the digital one, has less noise, cost and processing challenges in high frequency applications. Simulation results obtained from applying the proposed method on a GaN-based synchronous boost converter in two different switching frequency ranges (100KHz and 1MHz) are indicative of the proposed strategy advantages.

In this article, a novel topology of DC-DC converter based on voltage multiplier cell and coupled inductor with higher efficiency and low blocking voltage across semiconductor is proposed for renewable energy application. The recommended topology obtains a high voltage gain using voltage multiplier cell and one coupled inductor. Only one power switch is utilized in this structure, which reduces the converter's cost. The other benefits of this converter are low number of components, high efficiency due to the zero-voltage switching and the zero-current switching of diodes, and low blocking voltage of the power switch and diodes. Besides, the voltage multiplier cell acts as a passive clamp circuit and reduces the voltage stress across the power switch. Thus, a low rated power switch can be used in the presented topology. Due to the zero-current switching in Off-state, the reverse recovery problem of diodes is reduced. To illustrate the performance and superiority of the presented topology, operation modes, steady-state and efficiency analysis, and the comparison study with other similar converters are presented. Finally, a 160~W experimental prototype with 50~kHz switching frequency and 17 V input voltage are built to confirm the theoretical investigation and effectiveness of the proposed converter.